Micro Starter Harness Kit
Micro Starter Harness Kit was made so that a driver can easily
jump start their Corvette using just the unit without the need for
the clamps. This 12 inch harness connects directly to the battery while the other
end plugs directly into the Micro Starter.
Also included in the kit is an adapter that
converts the Micro Starter Harness (blue connector) down to an SAE
Connector (Battery Tender type), so you can easily hook up your battery
charger and eliminate the standard SAE harness you might have.
standard Battery Tender type Harness WILL NOT handle jump-starting as
the wire gauge is much to thin and it will melt the wires.Micro Starter Memory Saver XP1
Never again lug around the big, heavy, and bulky jump starter to keep the power to your Corvette's ODB port while you change the battery. With this cable you can just take your pocket sized Micro Starter and use it as the power supply to keep all the settings in your Corvette while you change the battery.
Micro Starter Replacement Clamps
- Please note: This will not work with the Micro Starter XP3 since that model only has USB ports.
These are a set of Micro Starter Replacement Clamps. They have a built in Diode to prevent back-charge to the Micro Starter from your Corvette.
NOTE: The Micro Starter is for jump-starting ONLY through the jump
start port! NEVER leave the Micro Starter connected to your Corvette's
battery for longer than 30 seconds or use in place of your regular
battery! DO NOT try to charge the Micro Starter directly from your
battery through the jump start port. SEVERE DAMAGE CAN RESULT!